Press guide
Your settings, application steps and wash care in one place. They work on cotton, polyester, blends and most things in between.
Temperature
285 to 305°F
Set before you start
First press
7 seconds
Full application press
Pressure
High
Firm and even
Peel
Hot or cold
Pause 2 to 3 sec, or cool fully
Finish every transfer: remove the film, cover with parchment or a Teflon sheet, then press again for 3 to 5 seconds.
The application
2 to 3 seconds
Lay the garment flat and press it for 2 to 3 seconds to drive out moisture and flatten the surface.
Check placement
Adhesive side down on the garment, carrier film on top. It will not stick until heat and pressure are applied, so take your time.
7 seconds
285 to 305°F for 7 seconds at high pressure. Keep the garment flat.
2 to 3 seconds
Open the press. For a hot peel, wait 2 to 3 seconds. For a cold peel, leave the film on until it is fully cool.
Hot or cold
Pull the film back in one smooth motion, low and close to the garment. Check that the whole design stayed down.
Peel while the film is still warm
After the 2 to 3 second pause, peel away the warm film in one smooth motion. Then move on to the finishing press.
3 to 5 seconds
With the film off, cover the design with parchment paper or a Teflon sheet and press 3 to 5 seconds more.
After pressing
Share these instructions with whoever will wear the garment.
Wait 24 hours
Allow 24 hours after pressing before the first wash.
Turn inside out
Wash with the printed side facing inward.
Wash cold & gentle
Use cold water and a gentle cycle.
Skip bleach & softener
Do not use bleach or fabric softener.
Dry on low
Tumble dry on low heat or hang dry.
Do not iron the print directly
Iron inside out or use parchment over the design.
Send us a photo of the transfer and tell us your garment type, press temperature, press time, pressure setting, and whether you peeled hot or cold. Those details help us understand what happened.
Build a new sheet, or grab a free sample first and judge the print yourself.